Cisco Unified Sip Proxy (CUSP)

Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cusp/rel10_2/cli_config/guide/cusp_cli_config/init_config.html#95660

When you log into CUSP CLI - and do a show running config - it does not show the CUSP config, but only the core setup.

How to configure

• To enter CUSP config, enter the command cusp
• Then to see the config, do a show configuration active
  • If you want to view ALL of teh config including the Routing Table - you must add the verbose command, e.g.

    show configuration active verbose

• to enter configuration mode, use the command configure
• To commit the configuration for this example, enter the following command:commit

Note

• see the current active configuration, enter the show configuration active command.
• To see what the active configuration will be after you commit your changes, enter the show configuration candidate command.

ROUTER#service-module SM 1/0 session
Trying 10.123.123.123, 2067 ...
% Connection refused by remote host

Update the config for line 67 as per below:

line 67
 transport input all

• Assign a ANI/CLI to the Campaign using the prefix configuration, which sets the REMOTE-PARTY-ID SIP header

• Create a Trigger on CUSP to match these against these specific calls

• Create Normalization Rule to prefix calls find and replace 00 with 0044

• Create a Pre-Normalization and assign it the Trigger and Normalization Rule