This is an old revision of the document!
Cisco Unified Sip Proxy (CUSP)
TIPs
When you log into CUSP CLI - and do a show running config - it does not show the CUSP config, but the core setup.
To enter CUSP config, enter the command
cusp
Then to see the config, do a
show configuration active
Prefix Digits on UCCE SIP Dialer on a specific campaign
- Assign a ANI/CLI to the Campaign using the prefix configuration, which sets the REMOTE-PARTY-ID SIP header
- Create a Trigger on CUSP to match these against these specific calls
- Create Normalization Rule to prefix calls find and replace 00 with 0044
- Create a Pre-Normalization and assign it the Trigger and Normalization Rule
