Cisco Unified Sip Proxy (CUSP)

This is an old revision of the document!

When you log into CUSP CLI - and do a show running config - it does not show the CUSP config, but the core setup.
To enter CUSP config, enter the command

cusp

Then to see the config, do a

show configuration active

see the current active configuration, enter the show configuration active command.
To see what the active configuration will be after you commit your changes, enter the show configuration candidate command.
To commit the configuration for this example, enter the following command:

se-10-1-0-0(cusp-config)> commit

Assign a ANI/CLI to the Campaign using the prefix configuration, which sets the REMOTE-PARTY-ID SIP header

Create a Trigger on CUSP to match these against these specific calls

Create Normalization Rule to prefix calls find and replace 00 with 0044

Create a Pre-Normalization and assign it the Trigger and Normalization Rule

Cisco Unified Sip Proxy (CUSP)

TIPs

Prefix Digits on UCCE SIP Dialer on a specific campaign